Posted on

marijuana seed taproot

Most seedling plugs will go back into place easily, and you'll barely be able to tell it's been opened ?

Since your seedling has already sprouted and has been in placed into the right growing position, it'll probably pop its head out within just 12-24 hours! Sometimes you see just the leaves, but occasionally you actually see the seedling push the shell above ground.

12 hours after that, the leaves have completely emerged!

The first thing to do is get a new Rapid Rooter. Since your seed already has a relatively long root, cut the plug open lengthwise so you can gently place the seedling inside in the right position without having to "push" down on the seed.

If you just wait a little everything will have righted itself ? Here's that seedling 12 hours later…

Other people in this thread seem to think that it’s a good idea to plant the seed as soon as it cracks..however this can be a bad idea..the tap root is what gives the plant its early root structure..and strength..allowing them to have this before planting gives the seedling a much better chance to survive any problems it may encounter in the soil..remember..soil is a living organism and has bacteria..a seed may get halted in its early growth by encountering any numbers of chemical reactions including chlorine shock..pests..or fungus..the ones with a half inch tap root..seem to be able to cope better..

the best thing is to let the seed develop a tap root to a length of about a half inch. I am also going to recommend and assume that you knew enough to let the seed(s) bob around in a glass of water that was allowed to sit for a few hours (to allow chlorine to gas out of the water. before putting the seeds in). and then put the glass of water and seeds into an empty drawer somewhere where there are no lights..and leave it there for 12-14 hours.."longer will risk drowning the seeds"..then you should have triangle folded a and dampened brown coffee filter..not white..white ones may contain bleach..which is also chlorinated..put the coffee filter triangle in a small tray and put the seeds very gently onto the filter.."don’t squish them or they will die"..after their soak they are delicate..so do this carefully..put a "once folded" coffee filter on top of the seeds..and wet it ..

gently place the seedling tap root down and gently push some soil in around it and then cover it gently with some more soil ( make sure you use regular potting soil with a decent amount of peril it in it..I like shultzs potting soil) spray (water @ 6.5 ph) the soil till it’s dark and wet but not puddling..place the potted plant under a 1300-2600k daylight (for vegging cycle) CFL..about 3 – 4 inches from the pot ..in about 2 days or less you will see your new seedling popping through the soil..if it takes 3 days I will be surprized..keep checking the seedling about 3 times a day..make sure to fine mist spray the soil and keep it dark..as the light will dry it out..don’t let it dry out until your plant gets about 4 inches and has its first real growth leaves..

you will see the outline of the seeds through it slightly once it’s wet..put the tray back in the drawer and use the water in the cup to wet the top filter a couple times each day..DO NOT LET THE FILTER DRY OUT BUT ALSO DO NOT LET THE SEEDS SIT IN A PUDDLE..after about three days the tap root will be around a half inch on the seeds..if not leave them until they are..once the seeds are ready..plant them each in their own small 4 inch pot by poking a whole down about an inch with a chopstick or your finger..

Then water the soil as you would with regular plants..allowing the soil to almost dry out up to an inch below surface..I usually water when I see the edges of the soil pull away from the pot sides..but for the seedling when it is still just in the baby leaves..keep the surface damp ..by watering or checking it every few hours..keep a light breeze (fan) circulating in the room..not directly on the plants though..especially when they are little. good luck

To obtain much better results, first germinate seeds in kitchen paper, jiffy pellets or peat plugs used for rooting cuttings and then transplant them to the soil or to a pot once the small seedlings have been born. Another benefit of this method is that we can germinate a large number of seeds in a very small space, such as a small greenhouse, which will make it much easier to provide the correct temperature and humidity.

We hope that this article will help you avoid problems when germinating your seeds, it can be very frustrating to start a grow with all the enthusiasm and excitement, only to run into problems straight away! Do not hesitate to leave us any doubts, comments or your own tips and tricks, we’ll be happy to answer you.

Direct germination in soil

A heated greenhouse is perfect for germinating seeds

Pothead 2021-05-12
This article has a lot of nonsense in it. From Mandala Seeds: A #1 seed killer is a closed humidity dome/mini-greenhouse. Humidity domes are only required for rooting cuttings. Many growers make the mistake of thinking that they need a high ambient humidity for germination or seedlings. This is an unfortunate myth of cannabis cultivation. The high humidity and lack of fresh ventilation quickly causes fungus in the soil or growing medium and the seeds can rot! Cannabis is not an orchid or swamp plant! The seeds need a well aerated growing medium to germinate well. Seedlings also cannot tolerate high humidity and can easily be attacked by fungus such as fusarium and pythium. Only the soil or growing medium should be moist for optimal germination and seedling growth. Ambient humidity is best at or below 50%. Btw, seed should be planted with the pointed end UP, not down. Tap root ALWAYS goes up no matter how you place the seed. It's by the nature, goes against the gravity to create a support for itself so it can push the seed out. It you put it with the pointed end down it will have to make double turn loosing the precious energy stored in the seed.

For this reason, it is advisable to check every day to make sure the germination medium remains moist, especially if a heat source is used to achieve a higher temperature and therefore a better germination rate; the heat will cause the substrate to dry more quickly, something that must be kept in mind to avoid nasty surprises. In case of hydroponic cultivation it is always better to germinate in rock wool cubes, which of course must always remain moist.