Posted on

germinating marijuana seeds in jiffy pellets

After waiting a gruelling 56 hours (Just over two days) I was going to sleep and noticed the first seedlings erecting from the jiffy pellets. It worked! Over the next 24 hours, the others sprouted one by one. This happened until all six plants were standing strong. The jiffy pellets had a 100% success rate. This was amazing for my grow. After they sprout they are ready to be placed under your grow lights (or in the sun if your doing it that way)

The other three sprouted one day after this.

I then carefully placed the cannabis seeds inside the hole with a small pair of tweezers. This ensures no harm is done with my fingers. After placing in the dirt, I covered up the hole carefully. I did this for all six pellets.

Step 2: Add water to the jiffy pellet

The first problem I faced was how to germinate the seeds.. what does germinate even mean?

Seedlings a week after germination.

Once planted you need to leave them inside the container at room temperature for up to eight days. The germination process takes anywhere from 2 – 8 days to get the seedlings to sprout. After the first 24 hours, the pellets seemed very dry. I then proceeded to add a little water to each to keep them moist.

Here is a 6 step guide on how to germinate cannabis seeds for beginners using jiffy pellets. This method was 100% successful for me and i wanted to share it with everyone else looking to start growing for the first time.

Completely saturate the jiffy-pots and their contents, but allow them to drain well. Do this carefully so as not to wash the fine soil away. Top them up and repeat if the mix has sunken too much. It’s important to have them as full as possible to give the young roots plenty of room to grow for the week or two until they are potted on, and, because having a greater volume of the mix in the pots means they take longer to dry out under the warm lamp.

Soil fungus
Seeds may rot, or the young seedlings may fall over. Overwatering, poor drainage and lack of aeration will increase the likelihood of this occurring. Plant seeds in sterilized potting mix, and make sure your containers are clean.

Perlite preparation

Transfer jiffy-pots into pre-warmed propagator tray, and settle them in making sure the wet perlite surrounds the pots, getting right up between them. This ensures the pots stay moist until well after the seeds germinate, protecting the young roots from drying out.

Now that the plants have strong light they require more water and nutrients as well. A light organic feed or nutrient solution starting with an E.C of no more than .8 (with the water already at .5) can be sprayed directly on the plant and watered into the soil. The seed-raising mix contains no nutrients so within a few days the plants will be hungry.

Soil too firm
Making your soil mix too firm can prevent oxygen from getting to your seeds and drainage can be affected. Pat freshly covered seeds lightly with your fingers.

You should NOT soak the jiffy pellets. They will become too wet and if you squeeze them out they can become unstable.

Once the seeds have broken through the soil, they will need to be placed on either a 24/0 or 16/8 light schedule to start the germination phase.

Instead, we need to slowly pour 1 cup of water over them. Then wait several minutes until they expand.

Take one of your seeds and put it about .5″ deep in the pellet. It does not matter which way the seed is turned. Cover it with some of the top soil.

Anywhere from 2-8 days later, you will see your marijuana seeds begin to pop their heads out of the jiffy pellets. This will not happen to all your seeds at one time, so be patient and do not mess with the ones that need a little extra time.