The pH value of your soil will determine how well your plants can access the nutrients within. If the pH becomes too high (alkaline) or too low (acidic), nutrient lockout will occur and deficiencies will set in. Cannabis plants thrive in a soil pH of between 6.0 and 6.5. Use a pH tester to track pH throughout your grow.
After you’ve prepared the mix, add some Easy Boost Organic Nutrition to the blend. These pellets will slowly release adequate levels of nutrition into the soil, providing foundational elements and minerals for the entire growing cycle. Add some mycorrhiza to the soil to help your plants flourish later down the line. These symbiotic fungi will bind to the root system and help your plants uptake nutrients more effectively.
A NOTE ON PH
Autoflowering strains typically move from seed to harvest in 8–10 weeks. However, some varieties can take up to 12 weeks to fully mature. Strains such as Bubble Kush Automatic and Quick One fall towards the faster end of the spectrum, whereas varieties like Royal Creamatic and Royal Haze Automatic take a few more weeks to ready their buds for harvest.
Many growers elect to cultivate autoflowers because of their speedy growing rate. Their hardy genetics and forgiving nature also make them easier to grow and therefore more beginner-friendly.
Next, poke a 10–15mm hole into a pot with your soil mix. Sow your seed directly into its final pot to avoid the stress of repotting later down the line. Transplanting causes plants to go into shock, and autoflowers grow so fast that they’ll struggle to recover. Place a seed in the hole and cover lightly with soil. You’ll see your seedling emerge in the next few days.
Follow the fail-safe week-by-week grow guide below for a quick and easy route to harvest time. We cover all of the parameters and variables you need to consider—at the correct times—to ensure your plants remain healthy, vigorous, and productive.
As for the right type of light, LEDs are now replacing HPS lighting in grow rooms and tents everywhere. They may be more expensive outright, but they use a lot less energy than HPS, so you will save massively on energy costs over time. If you’re using an LED grow light, you may want to see whether it is also equipped with UV lights. Some growers say that UV light makes for better taste and potency.
60–65 days from planting your seeds. Since many autoflowers won’t get taller than 50–70cm, they are ideal for growing indoors, where space is often limited.
TIP 6: TRY THE SEA OF GREEN METHOD
As the lifespan of autoflowering cannabis is limited, it is less forgiving when it comes to major stressors and mistakes. When plants experience high amounts of stress, growth stalls; while this may be fine for conventional cannabis that can be kept in veg longer to recover, autoflowers don’t have that luxury—they will flower regardless. As such, it’s best to start autos in their final pot right from the get-go to avoid transplant shock.
Cannabis can only uptake nutrients when the soil surrounding the root zone has the right pH value. The optimal pH range here is 6.0–7.0. For growing in other media, such as coco, the pH should be lower, ranging from 5.5–6.5. If the pH of your water is not optimal (which is likely the case if you use tap water) and plants can’t uptake nutrients, this leads to sick specimens. The right pH is particularly important when growing autoflowers as they don’t have time to recover. You want to ensure your plants get all the nutrients they need during their short period of growth.
Autoflowers don’t have all the time in the world to grow. Right after sprouting, your plant will need to spend a good amount of time establishing a healthy root system. When you administer a root stimulant immediately after placing your seed in the pot, this will support your plant in this crucial process. But don’t go overboard as your seedling will be very sensitive to overfeeding. Use only the minimum recommended dose of root stimulant.
Now is when you’ll need to transplant your autoflowering plants to their permanent home. Autoflowering strains that take two months prefer pots that are about 7L, whereas those that take three months much prefer pots that are 11L, no bigger.
The first thing that you’ll need to do is germinate the seed properly, using the paper towel method that we’ve talked about here before.
Germinating Autoflowering Cannabis Seeds:
Fill the pots with soil first and then water them; once the plant breaches the top of the soil you mustn’t wet it again. If you water it before the seed has come out then it will probably move up towards the surface which can cause a whole list of other issues. The best thing to do is to water first and then wait to water it again until the sapling grows a bit.
I use a liter of water with Canna Terra Professional, and no excess water comes out of the holes in the flowerpot which means it’s adequately watered. You can read all about substrates here.
Up until this point the process has been exactly the same for seasonal seeds, but that’s about to change. You’ll need to wait for the plant to break the surface and have that little growth spurt that cannabis plants tend to get when they’re looking for light. This can take 4 or 5 days, and you’ll need to keep a close eye on them so you don’t leave them for too long. Make sure that the plant doesn’t begin to develop in that flowerpot, the maximum time you should leave the plant in it is 6 days.